Magic Araxxor
Araxxor: Magic
Introduction
This is an advanced guide which assumes a strong underlying knowledge of all mechanics and information presented in #araxxor-basic. Each path subsection contains the relevant strategies for p1-3. P4 is the same for all paths.
Preset and Relics
Preset Notes
⬥ It is recommended to have the NopeNopeNope perk from Player Owned Farms active.
⬥ Upkeep the 
buff from your familiar.
⬥ Araxxor takes a few seconds to clear vulns on phase 1-3, making vuln bombs 
usable on all phases.
Top Path
⬥ Phase 1
• This phase is timegated so it can be used to set yourself up for p2 while you deal damage
• Stall 
when the web burn reaches ~80%
• Release with 
then build and 
at close to 100% web burn
• then build adren till web burns completely
• You may wait for Araxxor to do a special attack after web finishes burning before going into phase 2 (not needed but provides safer skips)
⬥ Phase 2
This phase is skipped
Turn towards web, and when it burns, drink the 
and 
→ 
→ → → straight to phase 3, then immediately drop a 
⬥ Phase 3
While waiting for Araxxor to come up the path do the following (use filler abilities as needed)
+ 
→ 
→ 
→ s 
When Araxxor is within range of your , swap your autocast spell to 
and do the following
r (disassemble your ) → 
→ 
→ if Araxxor heals or if this fails to phase him, then improvise
Middle Path
⬥ Phase 1
• Walk Araxxor so he is right against the web (see below how to walk p1)
• At 99% web burn you can bladed dive + surge into phase 2
⬩ You'll know if you did it correctly if Araxxor starts absorbing the acid at 1:06 rather than the standard 1:12. This can be delayed if rax does a spec right before the web finishes burning.
• Below is a diagram to help with positioning Araxxor on P1 (Camera facing east)
⬩ The yellow line is the line to stand on after walking Araxxor, if you move 1 more square east Araxxor will run into the web and start going west again which could ruin the setup. If you have trouble finding this spot just keep in mind you must stand 1 east of the line where the skulls are (circled in red).
• Here is a video example on walking Araxxor in P1:
⬥ Phase 2
• Run across the acid pool and 3 tiles onto the ramp. This puts Araxxor as far up the path as he can be while still absorbing acid.
• Deal damage
• When rax has absorbed 53% acid, you can + up the ramp, then walk 1 tile west so you have room to dodge cleave specials at the top of the ramp.
⬩ You'll know you did this correctly if rax goes up to 55% then starts dropping, and you'll get the popup message that the bridge is burning when there is 49% acid left. This is the perfect amount needed.
• Set up for phase 3
⬩ Natural instinct timing is calculated based on how much acid rax has poured onto the bridge. The timing is roughly when the bridge has absorbed 25-30% acid. Under normal circumstances, this means the popup would appear at 49%, so you would when the bar says 24-19%.
• and 
then build to 100%
⬥ Phase 3
(tc) 
+ + + 
→ → 
→ → →
Bottom Path
⬥ Phase 1
• No special setup. Just DPS Araxxor down to <5k hp.
⬥ Phase 2
• No special setup. Follow the light and wait for the charge. Stay at 100% adrenaline.
• When you dodge the charge and Araxxor damages the wall, you can click the minimap to start running into phase 3, and then right click Araxxor when he is going up into the ceiling so you can right click 'attack' instantly in phase 3. This is nice in case minions spawn during p2 to avoid Target Cycle targeting them instead of Araxxor.
⬥ Phase 3
+ + 
→ 
→ → → → → → →
Phase 4
This rotation is the same regardless of which path you took.
+ + → build → 
→ 
→ → 
→ →
Alternatively you may choose to do the following if bringing a range switch (this is preferred):
+ + → → 
+ → → 
→ 
→ (tc) + + 
→ → → 
→ improvise if not dead
Note: If you do not have your , improvise
Example Kills